Pautas de perforación de orificio profundo
Step 1: Pilot Hole
- 100 % RPM
- 100% IPR (mm/rev)
Details:
- Establish the pilot hole using the same diameter short drill to a depth of 2xD minimum.
- Utilize a pilot drill with the same or larger included point angle.
Step 2: Feed-in
- 50 RPM max
- 12 IPM (300 mm/min)
Details:
- Feed the longer drill within 1/16" (1.5mm) short of the established pilot hole bottom at a maximum of 50 RPM and 12 IPM (300 mm/min) feed rate.
Step 3: Deep Hole Transition Drilling
- 50 % RPM
- 75% IPR (mm/rev)
Details:
- Drill additional 1xD past the bottom of the pilot hole at 50% reduction of recommended speed and 25% reduction of recommended feed.
- Minimum of one second dwell is required to meet full speed before feeding.
Step 4: Deep Hole Drilling - Blind
- 100% RPM
- 100% IPR (mm/rev)
Details:
- Drill to full depth at recommended speed and feed for longer drill according to Allied speed and feed charts.
- No peck cycle recommended.
Step 5: Deep Hole Drilling - at Breakout
Details:
For through holes only:
- Reduce speed by 50% and feed by 25% prior to breakout.
- Do not break out more than 1/8" (3mm) past the full diameter of the drill.
Details:
- Reduce speed to a maximum of 50 RPM before retracting from the hole.
Tool failure can cause serious injury. To prevent:
- When using Superion drills greater than 9xD without support bushing, use a short Superion drill to establish an initial hole that is a minimum of 2 diameters deep.
- Do not rotate drills more than 50 RPM unless it is engaged with the workpiece or fixture.
Visit
www.alliedmachine.com/DeepHoleGuidelines for the most up-to-date information and procedures.
Factory technical assistance is available for your specific applications through our Application Engineering department.
North and South America and Asia: 1-330-343-4285 ext: 7611 | email:
appeng@alliedmachine.com
Germany: +49 (0)7022 408-0 | email:
info@wohlhaupter.de
United Kingdom: +44 (0) 1384 400 900 Ext. 4 |
engineering.eu@alliedmachine.com
La falla de las herramientas puede provocar lesiones graves. Lo que se debe evitar:
- Cuando se utilizan sostenes sin buje de soporte, use un Holder T-A® corto para establecer un orificio inicial que tenga una profundidad mínima de 2 diámetros.
- No rote los portaherramientas más de 50 RPM a menos que esté acoplado a la pieza de trabajo o accesorio.
Visite
www.alliedmachine.com/Support/Safety/Deep-Hole-Drilling-Guidlines/T-A®-and-GEN2-T-A®.aspx para obtener la información y los procedimientos más actualizados. La asistencia técnica de fábrica está disponible para sus aplicaciones a través del Equipo de ingeniería de aplicaciones.