15
15
GEN3SYS XT Pro
ATV Suspension: GEN3SYS® XT Pro 
Code:
1301
Share on Facebook    Share on Twitter    Share on LinkedIn    Email a friend
The Challenge

Increasing your production might be easier than you think. 

If you’re struggling with production issues, don’t beat your head against the wall. Taking a look at your penetration rates can quickly improve your machining processes. Our customer was producing ATV suspensions from ductile iron, a material with high abrasiveness and inconsistent hardness. The application was challenging, and the customer wasn’t happy with the low penetration rate they were getting from their current drill; they needed to maintain a 63 Ra μin surface finish, and if they fed the drill higher than .005 IPR (0.127 mm/rev), it wouldn’t hold the required finish.

The customer tested the GEN3SYS XT Pro using the “K” geometry with AM440 coating designed specifically to overcome wear in cast iron material. This coating allows you to spin the tool faster without losing the cutting edge to wear. The XT Pro demolished the customer’s expectations and increased the penetration rate from 8 IPM (203.2 mm/min) to 43.7 IPM (1109.98 mm/min), all while holding the required 63 Ra μin surface finish.

By increasing the penetration rate, the XT Pro dropped the cycle time from 23 seconds to 4 seconds. This allowed the customer to get more parts off the machine per hour, which further decreased the machine costs and ultimately increased profits. And no one’s going to complain about increased profits.

With the XT Pro, the customer successfully improved the production of their part. That’s all it takes; a simple change to the right tool can make all the difference in your production.

Find an Allied tooling distributor near you.

Product GEN3SYS XT Pro
Objectives Increase penetration rate
Industry Automotive
Part ATV Suspension
Material Ductile Iron
Hole Ø 1.024" (26.0mm)
Hole Depth 3.000" (76.2mm)

 
The Solution
GEN3SYS XT Pro High Penetration Drill
  • Drill holder, 3xD length:  HXT0326S-125F
  • Drill insert, K geometry (cast iron):  XTK26-26.00
Measure Replaceable Insert Drill GEN3SYS XT Pro
RPM 1600 1900
Speed Rate 429 SFM (130.759 M/min) 509 SFM (155.143 M/min)
Feed Rate 0.005 IPR (0.127 mm/rev) 0.023 IPR (0.584 mm/rev)
Penetration Rate 8.0 IPM (2032 mm/min) 43.7 IPM (1109.98 mm/min)
Cycle Time 23 sec 4 sec
Tool Life 1200 linear inches (30.48M) 1200 linear inches (30.48M)

 
The Advantages
The cast iron geometry insert with AM440 coating + the holder with enhanced coolant design provided:
  • 446% penetration rate increase
  • Decreased cycle time
  • Maintained customer's tool life